Industrial Cabinet Spray Washer with a Vertical Mount Turntable

industrial cabinetAEC Systems offers a number of product lines to suit a variety of cleaning needs. We also design cleaning systems specific to certain parts, for instance: the above industrial cabinet spray washer with a vertical mount turntable.

This industrial cabinet spray washer has a part work envelope of up to 40 inches in diameter (additional sized washers are available). Its cycle time from load to unload is 10 minutes.  The operator places a part or parts (for this washer it is a tube) on a cleaning fixture located on a vertical-driven turntable and clamps that part in place.  The operator then closes the door and pushes the cycle start button, and the vertical turntable automatically starts to rotate as the wash pump starts up.

There are spray nozzles located in a semi-circle outside of the diameter of the turntable that will spray the inside of the tube as it rotates, and there are additional spray nozzles that will spray the outside of the tube at the same time.  Once the wash cycle has timed out and tube drains solution from both ends of the tube, a blow-off cycle will start up, drying the tube as it continues to rotate on the turntable.  When the drying cycle stops, the operator opens the door, removes the clean and dried part, and replaces it with another dirty part to start the cleaning cycle over again.

Note: Filtration for chips and oil can be added to any of AEC Systems’ washers.

If your company has a part that needs to be cleaned to specification, contact us today.  Let’s talk about how we can make a parts washer that will accommodate your exact cleaning requirements.